![reclaime file recovery trail reclaime file recovery trail](https://i3.ytimg.com/vi/jnyRltTA2T4/hqdefault.jpg)
This How To assumes you use a USB HDD dock This can be a spare PC with spare disk ports, or an external HDD mount. This How To assumes you have a NAS with enough spare storage available, and is accessible on the network and ready for writing. Likewise, if you had 5 x 3TB drives, you’ll need 15TB storage available on the network.
![reclaime file recovery trail reclaime file recovery trail](https://datarecoverydigest.com/images/product-screenshots/04727e87-2a9e-4be6-9739-df9a06f1337e.png)
If you had 3 x 1TB disks in RAID 5, you will need at least 3TB storage elsewhere. Reason: an equal amount of space available somewhere else. A NAS or spare PC with significantly large network storage share. To enable you to recover the data, you’ll need to have the necessary hardware.ġ. Where possible, the entire RAID recovery needs to be performed in one long period without interruption. Don’t switch it back on until you can pass the next step. While like this, there is the potential for extra writes to occur on those disks and this risk needs to be eliminated. Reason: your existing PC is a plague to your RAIDed disks at the moment, the controller can likely still access your disks and thinks it’s in its old raid config. A lot of variables have to align to allow you to recover, but before admitting defeat stick your chin up, take a deep breath, and … switch your PC off. Hopefully you already have the necessary hardware available to recover but if not, you’ll need to make a few purchases.ĭepending on how the following steps pan out, you may not be successful in data recovery and you should accept that is a possibility. It is generic, and where assumptions are made they are stated.įailing to have a recent backup is going to be expensive. This How-To addresses recovering data from failed RAID 5 arrays on Desktop PCs, a situation we all dread (and should avoid by running OBR 10). If so, things may not be as bad as they seem and indeed, you may be able to recover everything. possibly an incorrectly referenced or corrupt RAID config. It’s unlikely to be a hardware issue on both drives, so it could be a software issue. Two disks dropping out of a RAID 5 simultaneously is odd. Well, keep breathing, but stop everything else. What to do? WHAT TO DO!?!įirst things first – stop.
#RECLAIME FILE RECOVERY TRAIL SKIN#
Your skin pales as you realise your last backup was *coughcough* months ago and close to useless. Then, through some elder gods’ handiwork, two of your disks drop off the RAID at the same time rendering your RAID 5 inaccessible. So, you’ve ignored SAM and gone and run on a RAID 5.